5.9.10. Community ID Setting
In default server or custom server mode, you can manually enter the cell identification
code or click the "Configure" button to scan the QR code of the cell and bind the device
to the corresponding cell. After the device is bound to the community, the face
management and access card management can be performed on the platform.
Community ID Setting
5.9.11. RTSP Setting
(1) Multicast: Enabled by default. After this option is enabled, only one indoor unit can
monitor the local unit at a time. Note: After this option is disabled, factors such as
bandwidth may affect the monitoring of multiple indoor units at the same time.
(2) Port: The default value is 8554. The value ranges from 1 to 65535. If the port of the
door unit is inconsistent with that of the indoor unit, the indoor unit cannot monitor
the door unit.
To Next Page
