GW Instek AFG-3000 Series - Sweep; Burst

AFG-3000 Quick Start Guide
18
Sweep
Example: Frequency Sweep. Start Frequency 10mHz, Stop frequency
1MHz. Log sweep, 1 second sweep, Marker Frequency 550 Hz,
Manual Trigger, Trigger out, rising edge.
Output
Input: N/A
1. Press Sweep>Start (F3).
2. Press 1>0>mHz (F2).
3. Press Sweep>Stop (F4).
4. Press 1>MHz (F5).
5. Press Sweep>Type (F2)>Log (F2).
6. Press Sweep>SWP Time (F5).
7. Press 1>SEC (F2).
8. Press Sweep>More (F6)>Marker
(F3)>ON/OFF (F2)>Freq (F1).
9. Press 5>5>0>Hz (F3).
10. Press Sweep>More (F6)>TRIG out
(F4)>ON/OFF (F3)>Rise (F1).
11. Press Output.
12. Press Sweep>Source (F1)>Manual
(F3)>Trigger (F1).
Burst
Example: Burst Mode, N-Cycle (Internally triggered), 1kHz burst
frequency, Burst count = 5, 10 ms Burst period, 0˚ burst phase,
Internal trigger, 10 us delay, rising edge trigger out
Output
Input: N/A
1. Press FREQ/Rate>1> kHz (F5).
2. Press Burst>N Cycle (F1)>Cycles (F1).
3. Press 5>Cyc (F5).
4. Press Burst>N Cycle (F1)>Period (F4).
5. Press 1>0>msec (F2).
6. Press Burst>N Cycle (F1)>Phase (F3).
7. Press 0>Degree (F5).