GW Instek GDM-8246 - Page 9

GDM-8246 MULTIMETER
PROGRAMMER MANUAL
⎯ 16 ⎯
:CONFigure:SFRequency Sets frequency function.
:CONFigure:RESistance <NR2> Sets resistance function and range.
:CONFigure:VOLTage:AC <NR2> Sets AC voltage function and range.
:CONFigure:VOLTage:DC <NR2> Sets DC voltage function and range.
:CONFigure:VOLTage:ACDC <NR2> Sets AC+DC voltage function and
range.
:CONFigure:VOLTage:DCAC <NR2> Sets Ripple voltage function and
range.
:READ? Returns the value displayed on the
primary and secondary display
:VALue? Returns the value displayed on the
primary display.
:SVALue? Returns the value displayed on the
secondary display.
GDM-8246 MULTIMETER
PROGRAMMER MANUAL
⎯ 17 ⎯
z
Calculation Commands
:CALCulation: LIMit:STATe? Returns Compare mode on or off.
:CALCulation: LIMit:STATe <Boolean>
Sets Compare mode on or off.
:CALCulation: LIMit:LOWer?
Returns the value of the lower
limit.
:CALCulation: LIMit:LOWer <NR2>
Sets the value of the lower limit.
:CALCulation: LIMit:UPPer?
Returns the value of the upper
limit.
:CALCulation: LIMit:UPPer <NR2>
Sets the value of the upper limit.
:CALCulation: LIMit:FAIL?
Returns the limit result.
:CALCulation:MAXimum?
Returns the MAX mode on or
off.
:CALCulation:MAXimum <Boolean>
Sets the MAX mode on or off.
:CALCulation:MINimum?
Returns the MIN mode on or off.
:CALCulation:MINimum <Boolean>
Sets the MIN mode on or off.
:CALCulation: RELation: STATe <NR1>
Sets REL mode on or off.
:CALCulation:RELation: STATe?
Returns REL mode on or off.
:CALCulation:RELation:DATa?
Returns the reference value of
the REL mode.
:CALCulation:RELation:DATa <NR2>
Sets the reference value of the
REL mode.