GDM-8261 Remote Viewer Guide
15
2. Click on the Setting(O)
menu and open the settings
dialog. Enter the default
settings as detailed below. For
more information on
configuring Sample Rate and
Recording, see the
measurement chapter on
page 17.
COM PORT: according to the Device Manager
Baud Rate: 115200 (Or the baud rate set above)
Test Speed: 500 ms
Record 1 in every: 1 measurement
Test Time: Continuous
3. Click on the Test Link button. The viewer
software and the GDM-8261 will try to establish a
connection (success), or an error message appears
(fail). If the connection is successful, a pop-up
message will return the model type, serial number
and firmware version.
To Next Page
Loading...
