OUTPUT
Square, triangle, sine, and pulse waveforms are provided
at up to 20V p-p amplitude (open circuit) at the OUTPUT (When
ATT pushbutton switch
is
pushed)
.
The VCF input and PULSE outputs, utilize
BNC
connectors.
VCF INPUT
A
VCF
(
voltage-controlled frequency
)
input
is
provided
for externally sweeping the frequency. Approximately +10V
applied at the VCF input
will
sweep the generator frequency
down to 10:l. The generator may also be swept up in frequency
by applying a negative voltage at the VCF input.
PULSE OUTPUT
The PULSE OUTPUT
is
a TTL or CMOS output signal suitable
for driving TTL or CMOS logic. The rise and fall time of the
PULSE output
is
typically 2511s. The pulse width and repetition
rate may be
set
as desired, utilizing the RANGE and MULTIPLIER
and DUTY control. The symmetry of the PULSE output
is
controlled
in the same manner as the output waveforms described in Table
2-1.
CMOS LEVEL CONTROL
The CMOS LEVEL CONTROL potentiometer (pull position)
provides CMOS LEVEL OUTPUT from 5V to 15V continuously variable.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
