GW Instek GFG-8020H - First Time Operation Procedure

PULSE OUTPUT SWITCH
Depress
the potentiometer switch and observe the TTL and CMOS
output push is TTL, pull is CMOS.
FREQUENCY COUNTER
COUNTER
DISPLAY
LED indicator display measured inte'rnal frequency.
GATE LED
Gate
signal indicates when push the gate time switch.
NOTE: Before
applying power to the Digital FUNCTION GENERATOR,
be sure the proper line voltage is available.
Plug the power cord into the proper source of 11OV.AC 50-60Hz.
All instruments
are wired for llOV AC unless otherwise order made.
FIRST TIME OPERATION PROCEDURE
Set the digital function generator controls as follows:
RANGE-HZ
10K
MULTIPLIER Max. CW
FUNCTION
DUTY
2,
CAL
AMPLITUDE MAX
OFFSET PUSH
ATTENUATOR
0 dB
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com