What to do if every startup a message appears that a revision might be needed on Gymna ShockMaster 300 Medical Equipment?
If you receive a message at every startup indicating that a revision might be needed, it means the handpiece counter has reached 1,250,000 hits. You should perform a revision and then reset the handpiece counter via the settings menu.
What to do if the Gymna ShockMaster 300 device doesn’t start?
If the device doesn’t start, begin by verifying the AC power socket and checking the mains cable. Then, measure the mains fuses and check the power supply. Ensure all internal connections are secure, especially the display connector. If problems persist, consider installing a new main board.
What to do if touch screen doesn't function on Gymna Medical Equipment?
If the touch screen isn't functioning, try recalibrating it. If that doesn't work, reload the software. As a last resort, install a new display.
Why is there no pressure output from Gymna Medical Equipment?
If there is no pressure output, test the output valves and power socket switch using the service menu. Also, verify the Pressure Control PCB and replace it if necessary.
What to do if shockwave output is too low on Gymna ShockMaster 300?
If the shockwave output is too low or irregular, perform a revision. If the issue persists, exchange the handpiece with a replacement.
How to fix the updater when it is not starting on Gymna ShockMaster 300 Medical Equipment?
If the updater is not starting, first verify that the software is properly installed on the memory stick. If you only see the installer “exe” file, clear the memory stick and run the installer to unpack the files. After unpacking, the USB-stick should contain the necessary files. Also, verify the memory stick is FAT or FAT32 formatted.
Why does the Gymna Medical Equipment compressor doesn’t stop in standby mode?
If the compressor doesn’t stop in standby mode, verify the air filter and all internal pressure connections. This issue is likely due to an air leakage.
What to do if the screen remains black after the update of Gymna ShockMaster 300?
If the screen remains black after the update, ensure you have updated to the latest software version (v6.0.4 or later). If the problem persists, try upgrading in two steps: first to v5.0.2, then to the newest version.
What causes whistling sound of pressure loss when the compressor starts on Gymna Medical Equipment?
If you hear a whistling sound of pressure loss when the compressor starts, replace the safety valve.
How to fix air leakage in connector of Gymna ShockMaster 300 Medical Equipment?
To fix an air leakage in the connector, exchange the handpiece with a replacement handpiece.
Purpose and application of the ShockMaster device in therapy.
Fields of application for radial shockwave therapy.
Conditions where treatment with ShockMaster is not permitted.
Requirements for operators and patients.
Qualifications for users and patient suitability.
Essential training for safe and effective device operation.
Identification of controls and features on the SM500.
Identification of controls and features on the SM300.
Lists standard components for ShockMaster 500 and 300.
Precautions to prevent ESD damage during installation.
Step-by-step instructions for setting up the device.
Guidelines for performing patient treatments safely and effectively.
Common issues and their corrective actions.
General| Brand | Gymna |
|---|---|
| Model | ShockMaster 300 |
| Category | Medical Equipment |
| Language | English |
To Next Page
