14 /
FOLDING AND MOVING OF TREADMILL
1 .Folding the Treadmill:
1) Disconnect the power before folding.
2) Set the incline of the treadmill to the lowest position.
3) Lift the treadmill to an upright position, and the Ezfit linking
parts will automatically lock onto the hydraulic mechanism
4) Verify that the Ezfit linking parts are securely locked onto the
hydraulic mechanism, as shown in the figure.
2 .Unfolding the Treadmill:
1) Choose a location about 1 meter away from the power outlet
with a flat and obstacle-free surface.
2) To unfold the treadmill, hold it with both hands and step on the
Ezfit linking part with your feet. The treadmill will slowly lower
to the ground automatically. Make sure to keep a distance of
about 1 meter from the treadmill until it is completely unfolded,
as shown in the picture.
3 .Moving the Treadmill:
When moving the treadmill, ensure the following:
1) The power switch of the treadmill is turned off.
2) The power plug has been disconnected from the socket.
3) The large frame has been folded.
After confirming the above points, hold one end of the
treadmill with one hand and the armrest on the same side
with the other hand. Tilt the machine to approximately 40-50°
towards the chest and move it slowly, as shown in the picture.
Ezfit linking
Wheel
Hydraulic
To Next Page
Loading...