15 /
TREADMILL MAINTENANCE
1. Lubrication(1-3 ml each time)
After the running belt has been used for a period of time, it is necessary to lubricate it with the
provided methyl silicone oil. Here are some suggestions based on usage time:
If you use the treadmill for less than 3 hours per week, lubricate the running belt once every 5
months.
If you use the treadmill for 4-7 hours per week, lubricate the running belt once every 2 months.
If you use the treadmill for more than 7 hours per week, lubricate the running belt once every
month.
Avoid excessive lubrication as it may cause issues. Proper lubrication is an important factor in
increasing the lifespan of the treadmill.
2. Checking for Lubrication:
To check if the running belt needs lubrication, lift the side of the treadmill and feel the center
back of the belt as much as possible. If you notice traces of silicon spray, lubrication is not
necessary. However, if the surface feels dry, it indicates that the belt requires lubrication.
Application of Lubricant on the Belt (as shown)
Stop the running belt and fold the treadmill.
Lift the back of the main frame to expose the middle position of the belt.
Spray silicone oil on the inner side of the running belt and coat silicone oil on both sides of
the running belt.
Start the treadmill at a speed of 1km/h to evenly
distribute the silicone oil on the belt.
Lightly step on the running belt from left to right to
ensure the oil spreads evenly.
Wait for several minutes to allow the silicone spray to
spread and settle.
Before using the machine, make sure the silicone oil has
properly distributed on the belt.
To Next Page
Loading...