H3C S6520X-SI Series Command Reference

8
Field
Description
Member ID
MAD IP address
Neighbor
MAD status
BFD MAD details:
• Member ID—IRF member ID of the local device.
• MAD IP address—MAD IP address of a member device.
• Neighbor—IRF member ID of the neighboring member device.
• MAD status—BFD MAD link state. The following values are available:
 Normal—BFD MAD is operating correctly.
 Faulty—BFD MAD is not operating correctly. Check the BFD MAD
link for connectivity issues.
 N/A—BFD MAD link status cannot be detected. If BFD MAD is
enabled on a management Ethernet port, it is normal that this field
displays N/A.
easy-irf
Use easy-irf to bulk-configure basic IRF settings for an IRF member device.
Syntax
easy-irf [ member member-id [ renumber new-member-id ] domain domain-id
[ priority priority ] [ irf-port1 interface-list1 ] [ irf-port2
interface-list2 ] ]
Views
System view
Predefined user roles
network-admin
Parameters
member member-id: Specifies the member ID of a member device. The value range for the
member ID is 1 to 10.
renumber new-member-id: Specifies a new member ID for the device. The value range for the
member ID is 1 to 10. The member device automatically reboots for the new member ID to take
effect. If you do not specify this option, the command does not change the member ID.
domain domain-id: Specifies an IRF domain ID in the range of 0 to 4294967295. Assign the
same domain ID to all devices you are adding to the same IRF fabric.
priority priority: Specifies an IRF priority in the range of 1 to 32. The greater the priority
value, the higher the priority. A member with higher priority is more likely to be the master.
irf-port1 interface-list1: Specifies interfaces bound to IRF-port 1. The
interface-list1 argument represents a space-separated list of up to n interface items. Each
interface item specifies one interface in the
interface-type interface-number form. In
Release 6510, the value for n is 8. In R6515P06 and later, the value for n is 16.
irf-port2 interface-list2: Specifies interfaces bound to IRF-port 2. A physical interface
can be bound to only one IRF port. The
interface-list2 argument represents a
space-separated list of up to n interface items. Each interface item specifies one interface in the
interface-type interface-number form. In Release 6510, the value for n is 8. In R6515P06
and later, the value for n is 16.
Usage guidelines
This command bulk-configures basic IRF settings for a member device, including the member ID,
domain ID, priority, and IRF port bindings.

H3C S6520X-SI Series Specifications

General

Brand	H3C
Model	S6520X-SI Series
Category	Switch
Language	English