5-1
z Support of the H3C WA series WLAN access points (APs) for commands may vary by AP model.
For more information, see Feature Matrix.
z The interface types and the number of interfaces vary by AP model.
z The models listed in this document are not applicable to all regions. Please consult your local sales
office for the models applicable to your region.
5 DHCP Server Configuration Commands
z The DHCP server configuration is supported only on VLAN interfaces and loopback interfaces. The
subaddress pool configuration is not supported on loopback interfaces.
z Support for DHCP server configuration commands depends on the AP model.
DHCP Server Configuration Commands
bims-server
Syntax
bims-server ip ip-address [ port port-number ] sharekey key
undo bims-server
View
DHCP address pool view
Default Level
2: System level
Parameters
ip ip-address: Specifies an IP address for the BIMS server.
port port-number: Specifies a port number for the BIMS server in the range 1 to 65534.
sharekey key: Specifies a shared key for the BIMS server, which is a string of 1 to 16 characters.
Description
Use the bims-server command to specify the IP address, port number, and shared key of the BIMS
server in the DHCP address pool for the client.
To Next Page
Loading...
