H3C WA2612-AGN - User Manual

To Next Page

H3C WA Series Access Points

Web-Based Configuration Guide

Hangzhou H3C Technologies Co., Ltd.

http://www.h3c.com

Document version: 6W106-20130802

Main Page

Documentation Set4
Obtaining Documentation5
Technical Support5
Documentation Feedback5
Table of Contents6
About the WA Series Access Points Web-Based Configuration Guide14
- Applicable Models and Software Versions14
- Feature Matrix14
Quick Start16
- Quick Start Wizard Home Page16
- Basic Configuration16
- Admin Configuration17
- IP Configuration18
- Wireless Configuration19
- RADIUS Configuration20
- Encryption Configuration22
- Radio Configuration24
- Configuration Summary25
- Quick Start Configuration Examples25
Summary33
- Device Information33
- Displaying WLAN Service35
- Displaying Radio39
  - Displaying WLAN Services Bound to a Radio39
  - Displaying Detailed Radio Information39
- Displaying WDS42
- Displaying Client43
Device Basic Information Configuration48
- Configuring Device Basic Information48
  - Configuring System Name48
  - Configuring Web Idle Timeout Period48
Device Maintenance Configuration50
- Software Upgrade50
- Reboot51
- Diagnostic Information52
System Time Configuration54
- Displaying the System Time54
- Configuring the System Time55
Log Management Configuration56
- Displaying Syslog56
- Setting the Log Host57
- Setting Buffer Capacity and Refresh Interval58
Configuration Management60
- Backing up Configuration60
- Restoring Configuration60
- Saving Configuration61
- Initializing Configuration62
File Management Configuration63
- Displaying File List63
- Downloading a File63
- Uploading a File64
- Removing a File64
- Specifying the Main Boot File64
Interface Management Configuration65
- Displaying Interface Information and Statistics65
- Creating an Interface67
- Modifying a Layer 2 Interface69
- Modifying a Layer 3 Interface72
- Interface Management Configuration Example74
TR-069 Configuration76
- Configuration Guidelines78
User Management Configuration79
- Creating a User79
- Setting the Super Password80
- Switching the User Access Level to the Management Level81
SNMP Configuration82
- SNMP Overview82
- Configuration Task List82
- Enabling SNMP84
- Configuring an SNMP View85
  - Creating an SNMP View85
  - Adding Rules to an SNMP View87
- Configuring an SNMP Community87
- Configuring an SNMP Group88
- Configuring an SNMP User90
- Configuring SNMP Trap Function92
- Displaying SNMP Packet Statistics94
- SNMP Configuration Example94
Loopback Configuration100
- Loopback Operation100
- Configuration Guidelines101
MAC Address Configuration102
- Configuring a MAC Address Entry103
- Setting the Aging Time of MAC Address Entries104
- MAC Address Configuration Example105
VLAN Configuration107
- Overview107
- Recommended Configuration Procedure107
- Creating a VLAN108
- Modifying a VLAN108
- Modifying a Port109
- VLAN Configuration Example111
- Configuration Guidelines112
ARP Configuration114
- Overview114
  - Introduction to ARP114
  - Introduction to Gratuitous ARP114
- Displaying ARP Entries114
- Creating a Static ARP Entry115
- Removing ARP Entries116
- Configuring Gratuitous ARP116
- Static ARP Configuration Example117
IGMP Snooping Configuration118
- Recommended Configuration Procedure119
- Enabling IGMP Snooping Globally119
- Configuring IGMP Snooping on a VLAN120
- Configuring IGMP Snooping on a Port121
- Displaying IGMP Snooping Multicast Entry Information123
- IGMP Snooping Configuration Example124
Ipv4 and Ipv6 Routing Configuration127
- Overview127
- Displaying the Ipv4 Active Route Table127
- Creating an Ipv4 Static Route128
- Displaying the Ipv6 Active Route Table130
- Creating an Ipv6 Static Route131
- Ipv4 Static Route Configuration Example132
- Ipv6 Static Route Configuration Example134
- Configuration Guidelines136
DHCP Overview137
- Recommended Configuration Procedure137
- Enabling DHCP138
- Creating a Static Address Pool for the DHCP Server138
- Creating a Dynamic Address Pool for the DHCP Server140
- Enabling the DHCP Server on an Interface142
- Display the Information of Assigned IP Addresses142
- DHCP Server Configuration Example143
DNS Configuration146
- Overview146
  - Static Domain Name Resolution146
  - Dynamic Domain Name Resolution146
- Recommended Configuration Procedure146
  - Configuring Static Name Resolution Table146
  - Configuring Dynamic Domain Name Resolution147
- Configuring Static Name Resolution Table147
- Configuring Dynamic Domain Name Resolution148
- Adding a DNS Server Address148
- Adding a Domain Name Suffix149
- Clearing Dynamic DNS Cache149
- DNS Configuration Example149
Pppoe154
- Overview154
- Configuring Pppoe Client154
- Displaying Pppoe Client Session Statistics156
- Displaying Pppoe Client Session Summary Information157
- Pppoe Client Configuration Example158
- Configuration Guidelines160
Service Management161
- Overview161
- Configuring Service Management162
Diagnostic Tools164
- Overview164
  - Ping164
  - Trace Route164
- Ping Operation165
  - Ipv4 Ping Operation165
  - Ipv6 Ping Operation166
- Trace Route Operation168
Web Overview170
- Logging in to the Web Interface170
- Logging out of the Web Interface171
- Introduction to the Web Interface171
- Web User Level172
- Introduction to the Web-Based NM Functions172
- Common Web Interface Elements180
- Configuration Guidelines184
- Troubleshooting Web Browser185
  - Failure to Access the Device through the Web Interface185
Radio Configuration188
- Configuring Radio188
- Configuring Data Transmit Rates192
  - Configuring 802.11A/802.11B/802.11G Rates192
  - Configuring 802.11N MCS193
- Configuring Calibration196
  - Channel Calibration Information196
  - Parameter Setting197
- Configuring Channel Scanning199
  - Configuring Channel Scanning Parameters199
  - Configuring AP Operating Mode201
- Configuring Channel Detection203
AAA Configuration206
- AAA Overview206
- Configuring AAA207
- AAA Configuration Example213
RADIUS Configuration217
- RADIUS Overview217
- Configuring a RADIUS Scheme217
- RADIUS Configuration Examples223
- Configuration Guidelines230
HWTACACS Configuration232
- HWTACACS Overview232
- Configuring HWTACACS232
- HWTACACS Configuration Example237
- Configuration Guidelines242
User Configuration244
- User Overview244
- Configuring a Local User244
- Configuring a User Group247
- Configuring a Guest248
  - Procedure for a Management Level Administrator to Configure a Guest248
  - Procedure for a Guest Administrator to Configure a Guest250
Certificate Management251
- PKI Overview251
- Configuring PKI251
- PKI Configuration Example262
- Configuration Guidelines267
Wireless Service268
- Access Service268
- Introduction to WDS275
  - Advantages of WDS275
  - WDS Network Topologies275
- Repeater Mode Overview277
- Workgroup Bridge Mode Overview277
Configuring Wireless Service279
- Configuring Access Service279
- Configuring WDS Service298
- Configuring the Repeater Service303
- Configuring the Workgroup Bridge304
- Wireless Access Configuration Examples307
- WDS Configuration Examples350
  - WDS Configuration Example350
  - WDS Point-To-Multipoint Configuration Example353
- Repeater Mode Configuration Example354
- Workgroup Bridge Mode Configuration Example358
Configuring ACL and Qos362
- Overview362
  - Introduction to ACL362
  - Introduction to Qos362
- Configuring an ACL363
- Configuring Priority Mapping378
  - Overview378
  - Configuration Procedure378
- Configuring a Qos Policy380
- Acl/Qos Configuration Example393
- Configuration Guidelines402
Configuring Wireless Qos403
- Overview403
  - Terminology403
  - WMM Protocol Overview404
- Enabling Wireless Qos405
- Setting the SVP Service406
- Setting CAC Admission Policy407
- Setting Radio EDCA Parameters for Aps407
- Setting EDCA Parameters for Wireless Clients409
- Displaying Radio Statistics410
- Displaying Client Statistics412
- Setting Rate Limiting413
- Configuring the Bandwidth Guarantee Function414
- Wireless Qos Configuration Examples417
Advanced Settings424
- Advanced Settings Overview424
- Configuring WLAN Advanced Settings426
- Advanced Settings Configuration Examples434
  - Band Navigation Configuration Example434
  - Multicast Optimization Configuration Example436
WLAN Security Configuration438
- WLAN Security Overview438
  - WIDS Attack Detection438
  - Blacklist and White List439
- Configuring WIDS439
  - Displaying History Record440
  - Displaying Statistics Information440
- Configuring the Blacklist and White List Functions441
User Isolation444
- Configuring User Isolation444
Index445

Other manuals for H3C WA2612-AGN

Configuration Guide41 pages

Fundamentals Configuration Guide137 pages

Command Reference131 pages

Need help?

Do you have a question about the H3C WA2612-AGN and is the answer not in the manual?

H3C WA2612-AGN Specifications

General

Model	WA2612-AGN
Category	Wireless Access Point
Wireless Standard	802.11a/b/g/n
Frequency Bands	2.4 GHz, 5 GHz
Maximum Data Rate	300 Mbps
Ethernet Ports	1 x 10/100/1000 Mbps
Antenna Type	Internal
Antenna Gain	5 dBi
Storage Temperature	-40°C to 70°C
Operating Humidity	5% to 95% (non-condensing)
Power over Ethernet (PoE)	Yes
Mounting Options	Ceiling, Wall