268
Figure 269 Configure clear type wireless service
3. Configure the basic settings for the clear type wireless service as described in Table 96.
4. Click Apply.
Table 96 Configuration items
Item Descri
tion
Wireless Service Display the selected Service Set Identifier (SSID).
VLAN (Untagged)
Enter the ID of the VLAN whose packets are to be sent untagged. VLAN
(Untagged) indicates that the port sends the traffic of the VLAN with the VLAN tag
removed.
Default VLAN
Set the default VLAN of a port.
By default, the default VLAN of all ports is VLAN 1. After you set the new default
VLAN, VLAN 1 is the ID of the VLAN whose packets are to be sent untagged.
Delete VLAN Remove the IDs of the VLANs whose packets are to be sent untagged and tagged.
SSID HIDE
•
Enable—Disable the advertisement of the SSID in beacon frames.
•
Disable—Enable the advertisement of the SSID in beacon frames.
By default, the SSID in beacon frames is advertised.
IMPORTANT:
•
If the advertising of the SSID in beacon frames is disabled, the SSID must be
configured for the clients to associate with the AP.
•
Disabling the advertising of the SSID in beacon frames does little good to
wireless security. Allowing the advertising of the SSID in beacon frames enables
a client to discover an AP more easily.
Configuring advanced settings for the clear type wireless service
1. Select Wireless Service > Access Service from the navigation tree.
2. Click the icon corresponding to the target clear type wireless service.
The page for configuring advanced settings for the clear type wireless service appears.
To Next Page
Loading...
