11-15
Modifying command level
All the commands in a view are defaulted to different levels, as shown in Table 11-3. The administrator
can modify the command level based on users’ needs to make users of a lower level use commands
with a higher level or improve AP security.
Follow these steps to modify the command level:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the command level in a
specified view
command-privilege level
level
view
view command
Required
See
Table 11-3 for the default
settings.
You are recommended to use the default command level or modify the command level under the
guidance of professional staff; otherwise, the change of command level may bring inconvenience to
your maintenance and operation, or even potential security problem.
Configuring the Number of Concurrent Users
Follow these steps to configure the number of concurrent users:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the number of
concurrent users
configure-user count
number
Optional
Two users are allowed to perform
the operation in system view.
z When multiple users enter system view at the same time to configure certain attribute, only the last
configuration applies.
z When the number of users has reached the limit, other users cannot enter system view.
Displaying and Maintaining Basic Configurations
To do… Use the command… Remarks
Display information on system version
display version
Display information on the system clock
display clock
Display defined command aliases and the
corresponding commands
display command-alias
Display information on terminal users
display users
[
all
]
Available in any
view
To Next Page
Loading...
