288
Item Descri
tion
STP
The following loop types may exist in a WDS network:
.
.When a loop exists in the network, you can block redundant links to
remove the loop by STP, and can provide link backup when a WDS
link fails.
Set STP.
• Enable—Enable STP.
• Disable—Disable STP.
By default, STP is enabled.
This configuration is applicable to only WLAN-mesh interfaces, and
global STP configuration (see "Configuring global WDS") i
s
applicable to all interfaces.
Link Maximum Number
Set the maximum number of WDS links allowed.
IMPORTANT:
If an AP needs to establish more than two WDS links, you must set this
number as required.
Link Hold RSSI
Set the link hold RSSI.
This is the minimum RSSI required to establish and hold a link.
Therefore, the minimum RSSI must be ensured. Otherwise, the error
rate can be very high and the link performance deteriorates.
ratemode
• fixed—The rate adopted is of a fixed value. It is the maximum rate
of the current radio.
• realtime—The rate adopted changes with the link quality, that is,
the rate changes with the change of the RSSI of the current radio.
The fixed mode is adopted by default.
To Next Page
Loading...
