H3C WA2620-AGN - Configuring an SNMP User

77
Item Descri
p
tion
Notify View
Select the notify view of the SNMP group, that is, the view that can send trap
messages.
If no notify view is configured, the agent does not send traps to the NMS.
ACL
Associate a basic ACL with the group to restrict the source IP address of SNMP
packets, that is, you can configure to allow or prohibit SNMP packets with a specific
source IP address, so as to restrict the intercommunication between the NMS and the
agent.
Configuring an SNMP user
1. Select Device > SNMP from the navigation tree.
2. Click the User tab.
The user tab page appears.
Figure 70 SNMP user
3. Click Add.
The Add SNMP User page appears.