H3C WX1804H Installation Guide

26
Displaying information about the device
Use the display device command to display information about the device.
<H3C>display device
Slot No. Subslot No. Board Type Status Max Ports
1 0 WX3510H Normal 16
Table 7 Command output
Field Description
Slot No. IRF member device ID of the device.
Board Type Device type.
Status
Device status:
• Fault—The device is faulty and cannot start up correctly.
• Normal—The device is operating correctly.
Max Ports Maximum number of ports supported.
Displaying the electronic label data for the device
An electronic label is a profile of a device. It contains the permanent configuration, including the
serial number, manufacturing date, MAC address, and vendor name.
Use the display device manuinfo command to display the electronic label data for the device.
<H3C>display device manuinfo
Slot 1 CPU 0:
DEVICE_NAME:WX3510H
DEVICE_SERIAL_NUMBER:210235A1JNC14B900031
MAC_ADDRESS:000f-e212-6103
MANUFACTURING_DATE:2017-03-23
VENDOR_NAME:H3C
Table 8 Command output
Field Description
DEVICE_NAME Device model.
DEVICE_SERIAL_NUMBER Serial number of the device.
MAC_ADDRESS MAC address of the device.
MANUFACTURING_DATE Manufacturing data of the device.
VENDOR_NAME Vendor name.
Displaying the CPU usage of the device
Use the display cpu-usage command to display the CPU usage statistics for the device.
<H3C>display cpu-usage
Slot 1 CPU 0 CPU usage:
0% in last 5 seconds
0% in last 1 minute
1% in last 5 minutes

H3C WX1804H Specifications

General

Brand	H3C
Model	WX1804H
Category	IP Access Controllers
Language	English