What to do if my Hach AMTAX sc Measuring Instruments shows 'COOLING FAILED'?
If the Hach Measuring Instrument displays 'COOLING FAILED', it indicates that the instrument's interior is too warm. The cause may be that the air filter is dirty or the fan is not working correctly. Inspect the air filter; clean or replace it if necessary. Also, check the fan to ensure it is functioning properly.
Why is my Hach AMTAX sc showing 'NO HEAT UP'?
If your Hach Measuring Instrument displays 'NO HEAT UP', it means the instrument is unable to heat the interior adequately, and the internal temperature remains below 20 °C (68 °F) for 30 minutes. To solve this, close the instrument and check the heating system.
What to do if Hach AMTAX sc shows 'ANALYZ. TO COLD'?
If the Hach Measuring Instrument displays 'ANALYZ. TO COLD', it indicates that the instrument's interior has been below 4 °C (39 °F) for more than 5 minutes. Close the instrument and check the heating to resolve this issue.
How to fix 'TEMP. < 0 °C/ 32 °F?' error on Hach AMTAX sc?
If the Hach Measuring Instrument displays 'TEMP. < 0 °C/ 32 °F?', it means the instrument was below 4 °C (39 °F) when it was powered on. Check if any components like the cleaning solution, sample, reagent, standards, or electrode are frozen. If necessary, use pre-warmed reagents and thaw the electrode. Delete the error, and the instrument will then continue to warm up and start.
General| Brand | Hach |
|---|---|
| Model | AMTAX sc |
| Category | Measuring Instruments |
| Language | English |
Explains the meaning of DANGER, WARNING, CAUTION, and Important Note symbols.
Provides a step-by-step overview of the instrument's installation process.
Information about installing the instrument physically.
Guides on how to open the analyzer enclosure safely, with warnings.
Explains how to determine the system configuration option and refer to connection guides.
Provides safety warnings for high-voltage connections and the protective cover.
Step-by-step guide to connecting the Filter Probe sc to the analyzer.
Provides safety warnings and instructions for installing reagents and chemicals.
Guides on installing and preparing the gas-sensitive electrode for operation.
Details safety precautions and procedures for supplying power to the analyzer.
Outlines the steps for initializing the instrument after installation and setup.
Details the sensor setup menu options for calibration, settings, and configuration.
Explains how to perform automatic and manual calibration processes.
Describes the steps for initiating and performing a measurement cycle.
Provides a table detailing chemical replacement intervals based on measuring ranges.
Guides on replacing the electrode's membrane cap, electrolyte, and the electrode itself.
Explains the process for performing regular validation checks on the instrument.
Lists common error messages, their causes, instrument reactions, and solutions.
Lists common error messages, their causes, instrument reactions, and solutions.
Lists common warnings, their causes, instrument reactions, and how to resolve them.
Details typical electrode values and troubleshooting steps for electrode-related issues.
To Next Page
