What to do if Hach DR 6000 says 'Insufficient memory for update'?
If the Hach Measuring Instruments displays 'Insufficient memory for update', it means there was an error during the update. Select a memory stick with more space.
What to do if Hach DR 6000 Measuring Instruments displays 'Error in FTP connection'?
If the Hach Measuring Instruments displays 'Error in FTP connection', it indicates an FTP error. Make sure that the instrument is connected to the network.
What to do if Hach DR 6000 displays 'Remote server unreachable!'?
If the Hach Measuring Instruments displays 'Remote server unreachable!', it means that the fixed address of the DR 6000 is not accepted, or the server name entered is incorrect. Switch to "Automatic" or enter the correct server name.
What to do if Hach DR 6000 Measuring Instruments displays 'Remote server cannot be reached'?
If the Hach Measuring Instruments displays 'Remote server cannot be reached', it indicates an error during network setup. Make sure that the instrument is connected to the network, as the fixed address of the DR 6000 may not be accepted.
What to do if Hach Measuring Instruments shows 'Too much ambient light' error?
If the Hach Measuring Instruments display an error indicating too much ambient light, it means the instrument sensors are detecting excessive light. Decrease the ambient light by moving the instrument into the shade, avoiding direct sunlight, or simply closing the lid.
What to do if Hach Measuring Instruments displays 'Error copying from USB memory stick'?
If the Hach Measuring Instruments displays 'Error copying from USB memory stick', it means there was an error during the update. Start the procedure again or contact technical support.
What does 'Error Selfcheck stopped. Hardware error' mean on Hach DR 6000?
If the Hach Measuring Instruments displays 'Error Selfcheck stopped. Hardware error', it indicates an electronic defect. Contact technical support and provide the error number.
Why is Hach DR 6000 recommending a Full System Check?
If the Hach Measuring Instruments recommends executing a Full System Check, it is because the check of the air values failed. Switch the instrument off and then back on again. If the system check is still not successful, contact technical support.
What to do if Hach DR 6000 Measuring Instruments displays 'System check incorrect!'?
If the Hach Measuring Instruments displays 'System check incorrect!', it means the measurement of air values failed. Switch the instrument off and then back on again. If the system check is still unsuccessful, contact technical support.
What to do if Hach Measuring Instruments says 'USB memory stick is not connected'?
If the Hach Measuring Instruments displays 'USB memory stick is not connected', it means that an update is not possible. Check the USB memory stick to ensure it is properly connected.
General| Wavelength Range | 190 - 1100 nm |
|---|---|
| Light Source | Tungsten and Deuterium lamps |
| Detector | Silicon photodiode |
| Wavelength Accuracy | ±1 nm |
| Wavelength Repeatability | < 0.1 nm |
| Photometric Range | ± 3.0 Abs |
| Photometric Linearity | ±0.002 Abs at 0.0 to 1.0 Abs |
| Stray Light | < 0.05%T at 340 nm |
| Display | 7 inch color touchscreen |
| Power Requirements | 100 - 240 V / 50 - 60 Hz |
| Connectivity | USB, Ethernet |
To Next Page
