Hachette ALIEN - Attach Pipe 7-4 to Head Section; Attach Pipes 7-5 and 7-6 to Head Section

4
5
4
5
7-4
7-1
7-1
7-5
7-6
KIT 7: CENTRE-LEFT SECTION OF THE HEAD
After test-fitting, apply a
little glue to Pipe 7-4 and
attach by slotting it over the
remaining two rectangular
blocks on 7-1.
Apply a little glue to the tabs on 7-5
and fit them into the first three slots
along the lower edge of the Head
Section 7-1. In a similar way, attach
Pipe 7-6 into the two remaining
slots. As always, check the fit of
pipes before glueing in place.