Need help?Do you have a question about the Hachette ALIEN and is the answer not in the manual?
Join the skull assembly (3-1) with Skull C (5-1) using screws (5-9).
Fit Skull Pipe 5-2 into the slots on the upper left side of Skull part 1-1.
Fit Skull Pipes 5-3 and 5-4 into the corresponding slots on Skull parts 1-1 and 3-1.
Fit Pipe 5-4 into the slots on Skull part 3-1 to continue assembly from Pipe 5-3.
Fit Pipe 5-5 into the next four slots along the skull assembly.
Fit Pipe 5-6 into the last four slots in Skull part 5-1.
Fit Pipes 5-7 and 5-8 into the slots under the lower edge of the skull.
Test-fit and glue Pipe 6-3 into the slots on the front-left section of the Head (6-1).
Slot Washer 10-5 into the central hole in Neck part 10-6.
Insert the thin end of Rod 11-4 into the assembly 10-5/10-6.
Insert Cap 11-2 into the assembly 10-5/10-6 with the flat side at the top.
Screw Cover 11-3 into Neck 10-6 to hold the ball joint in place.
Fit ball joint assembly 11-4 through part 12-1 and attach Skull Attachment Plate 11-1 with screws 12-5.
Position the skull assembly and fix it to Gearbox 2-8 using screw 12-6.
To Next Page
General
