22
KIT 12: THE HEAD AND SKULL
1
2
12-5
11-1
12-4
12-4
12-2
11-4
12-1
Take the ball joint assembly 11-4
and the Skull Attachment Plate
11-1 from the previous kit along
with Head 12-1. Take note of the
flat side at the top of the ball joint
assembly 11-4 which fits into a
correspondingly shaped recess
in part 12-1. Insert the ball joint
assembly 11-4 through part
12-1. Next, the Skull Attachment
Plate 11-1 is fitted in place using
four 2.3x6mm screws 12-5. There
is a shaped rib on the underside
of the plate (inset) to match the
shaped recess in part 12-1. The
screw sockets on part 11-1 face
upwards, as shown.
Fit a Bearing 12-4 onto
each end of the Lower Jaw
2 pieces 12-2, as shown.
To Next Page
Loading...
