Hafco BM-53VE - Introduction; Specifications

4
OPERATION MANUAL
Model Number: BM-23A BM-53VE BM-63VE
Digital Readout 3-Axis Counter X, Y Scales 3-Axis 3-Axis
Table Size (mm) 1066 x 230 1370 x 254 1370 x 254
Spindle Taper NT30 NT-40 NT-40
Longitudinal Travel X-Axis (mm) 585 910 890
Cross Travel Y-Axis (mm) 295 400 400
Vertical Travel Z-Axis (mm) 400 385 400
Type of Slides Dovetail (X, Y, Z) Dovetail (X) Square (Y & Z) Dovetail (X) Square (Y & Z)
Longitudinal and Cross Travel Type Lead Screws Lead Screws Ball Screws
Ram Travel (mm) 420 555 550
Quill Diameter (mm) 86 86 105
Quill Travel (mm) 127 127 127
Spindle to Table Max. (mm) 480 385 450
Throat Depth Max. (mm) 545 635
740
Tilting Head (Left to Right)
+90 ° +90 ° +90 °
Tilting Head (Forward & Back)
+45 ° +45 ° +45 °
Power Feed - Quill 0.04, 0.08, 0.15mm/rev 0.04, 0.08, 0.15mm/rev 0.04, 0.08, 0.15mm/rev
Power Feed - Longitudinal (X-Axis) 20-2000 mm/min 20 - 2000 mm/min 20 - 2000 mm/min
Power Feed - Cross (Y-Axis) Optional 20 - 2000 mm/min 20 - 2000 mm/min
Power Feed - Vertical (Z-Axis) Optional Rapid Rapid
Lubrication System One Shot One Shot One Shot
Table T-Slot Size (mm) 16 16 16
Work Table Load Capacity (Kgs) 250 350 400
Spindle Speeds Vertical 8 Steps (65-2330) rpm Variable (50 - 3550) rpm Variable (50 - 3550) rpm
Motor Power - Vertical 2.2kW/3HP 1Ph 3.75kW/5hp 3.75kW/5hp
Motor Voltage 240V-15amp 415V-20amp 415V-20amp
Overall Dimensions (mm./W x D x H) 1500 x 1700 x 2200 1800 x 2430 x 2200 1800 x 2430 x 2200
Net Weight (kgs.) 1100 1365 1375
The above specications were current at the time this manual was published, but because of
our policy of continuous improvement, we reserve the right to change specications at any
time and without prior notice, without incurring obligations
SPECIFICATIONS
This manual covers the safe operation and maintenance procedures for the Hafco/Metalmaster Turret
Mills with model numbers listed below in the specications. These machines have been designed and
constructed to provide years of trouble free operation if used in accordance with the instructions set
forth in this manual.
NOTE: Some sections may apply only to certain models. Please be sure you know your model.
INTRODUCTION
Page 4
Instructions Manual for BM-23A (M595D)
12/02/2018