Mounting Instructions
30
Mounting
Requirements:
•
DIN mortise lock
Depending on the design of the fixing plate, it is also possible to use
mortise locks on the Door Terminal Basic that deviate from the DIN
norm (e.g. for Austria).
The length of the following Door Terminal Basic components
depends on the thickness of the door leaf and must therefore be
selected appropriately:
•
the screws for attaching the rosettes
•
the square spindle
Tools required and auxiliary mounting materials:
•
a drilling template
•
an electric drill
•
drill bits suitable for the door material:
-
Ø = 8 mm
-
Ø = 7 mm (depending on the rosette fittings used)
-
Ø = 6 mm
•
a hammer
•
retaining ring pliers
•
a screwdriver
•
a 3 mm Allen wrench
To Next Page
Loading...
