Need help?Do you have a question about the Hafler P230 and is the answer not in the manual?
General| Power Output (8 Ohms) | 115 watts per channel |
|---|---|
| Power Output (4 Ohms) | 170 watts per channel |
| Total Harmonic Distortion | 0.03% |
| Input Sensitivity | 1.0 Volt |
| Signal-to-Noise Ratio | >100dB |
| Damping Factor | 100 |
Details amplifier's power output into various impedances and THD levels.
Specifies Intermodulation Distortion (SMPTE) from 1 watt to 115 watts into 8 ohms.
Defines the amplifier's frequency response at different power levels into 8 ohms.
Indicates typical channel separation across different frequencies.
Specifies the input voltage required for rated output power into 8 ohms.
Lists the types and quantities of semiconductors used in the amplifier.
Details quiescent and rated power consumption figures.
Describes internal protective fuses and thermal sensors for circuit protection.
Highlights MOSFETs' inherent protection against thermal runaway.
Instructions for connecting the amplifier to the AC power source safely.
Details on the 1/4" phone jack inputs and options for XLR connectors.
Information on binding posts for speakers and ground switch functionality.
Guidance for operating the amplifier in bridged mono mode for higher power.
Recommended procedure for powering the amplifier on and off.
Explains the pilot lamp's role in indicating power and thermal status.
Details on adjusting gain levels and selecting the ground switch position.
Information on speaker protection fuses, their purpose, and proper selection.
To Next Page
