Need help?Do you have a question about the Hafler trans-nova P4000 and is the answer not in the manual?
General| Power Output (8 ohms, stereo) | 200 watts per channel |
|---|---|
| Signal-to-Noise Ratio | >100 dB |
| Power Output (8 ohms, mono) | 600 watts |
| Total Harmonic Distortion (THD) | <0.05% |
| Dimensions | 19" W x 5.25" H x 15 inches (W x H x D) |
Guidance on amplifier placement for ventilation and noise avoidance.
Instructions for connecting to AC power and fuse replacement.
Details on XLR and 1/4" input jacks and their connection standards.
Information on speaker output connectors supporting various plug types.
How to configure for bridged mono operation and recommended impedance.
Location and function of the power switch and proper power sequencing.
Explanation of front panel controls for adjusting input sensitivity.
Using the Normal/Bridged Mono switch for stereo or mono operation.
Function of the CHASSIS/FLOAT switch for system compatibility.
Amplifier protection against speaker shorts and reset procedure.
Explanation of status LEDs for monitoring and troubleshooting.
Recommendation for amplifier warm-up for optimal sonic performance.
Guidelines for cleaning the amplifier's exterior and interior.
Design for technician-friendly modular construction and ease of repair.
Explanation of the trans•nova circuit topology and its advantages.
Block diagram of the P4000 amplifier's internal circuit interconnections.
Detailed schematic of the amplifier's circuitry with component values.
Diagram showing component placement on the printed circuit board.
Comprehensive list of all amplifier components with part numbers.
Detailed explanation of circuit functions like soft start and protection.
Step-by-step instructions for replacing amplifier modules.
To Next Page
