Need help?Do you have a question about the Hafler XL-600 and is the answer not in the manual?
Details amplifier power output and distortion ratings, including continuous power.
Specifies IM distortion, frequency response range, power bandwidth, and phase shift.
Outlines slew rate, signal-to-noise ratio, input impedance, and damping factor.
Lists the physical dimensions, weight, and shipping weight of the amplifier.
Instructions for cleaning the amplifier's faceplate and protective coating.
Guidelines for ensuring adequate airflow for continuous amplifier reliability.
Guidance on connecting the amplifier to AC power and remote switching.
Recommendations for connecting input cables and managing cable length.
Instructions for connecting speakers and ensuring proper phasing for stereo operation.
Steps for operating the amplifier in bridged mono configuration for higher power.
Explanation of the power switch function and the pilot lamp's status indication.
Details on the 3-second delay for output connection and protective relay functions.
Procedure for the initial system setup and amplifier power-on sequence.
Guidance on setting the mono/stereo switch for desired operation mode.
Information on speaker fuse holders, installed values, and replacement fuses.
Explanation of Excelinear technology for minimizing non-linearities and distortions.
Details on internal adjustments for fine-tuning amplifier channels to speakers.
General approach for amplifier adjustments using a driving source and monitor.
Diagram illustrating the straight wire differential test setup for amplifiers.
Step-by-step instructions for adjusting amplifier channels using potentiometers and capacitors.
Diagnosing loud thumps, DC voltage at output, and related speaker distortion.
Troubleshooting pilot lamp status, no sound, and internal fuse issues.
Contact information for customer service and procedure for returning units.
Details on the 3-year warranty coverage, including parts, labor, and shipping.
To Next Page
General
