6. Thread the power cable into one of the
guides at the back of the base.
7. Unscrew the locking screw.
Alternative
guides
Pozidriv 0
Pozidriv 0
8. Screw it back into the same place hence
locking the base in “table” position.
9. Close the base.
Pozidriv 2
10. Tighten the locking screw to prevent the
base from being opened by mistake.
11. Stick the 4 anti-slip pads to the back
of the base and then put it on the table.
187
GB
To Next Page
Loading...
