hager TX216 - Page 112

hager
"DALI Gateway C00Cx2" software
Parameters
Seite 112 von 130
Response to bus voltage
failure
Switch-off
Brightness value
No change
The Gateway permits to set separately the
brightness value for each DALI group after
a bus voltage failure.
The group will be switched off.
The group will be adjusted to the
brightness value specified in the drop-down
menu next to the parameter. The
adjustable value is restricted by the
parameterized minimum and maximum
brightness.
Following a bus voltage failure, the DALI
devices of a group will not react and keep
the current brightness value or remain
switched off.