hager
Fitting, electrical connection and operation
Seite 6 von 130
2.3 Fitting and electrical connection
DANGER!
Electric shock in case of accidental contact with live parts. Electric shocks can be fatal.
Before working on the device, cut out the mains supply and cover up live parts in the
surroundings!
Fitting
Fit the device by snapping it onto the mounting rail in acc. with DIN EN 60715. The screw terminals
should be on top.
• A KNX / EIB data rail is not required.
• Observe the temperature range (-5 °C ...+45 °C) and ensure sufficient cooling, if necessary.
To Next Page
Loading...