hager
"DALI Gateway C00Cx2" software
Parameters
Seite 114 von 130
Polarity of disable object
0 = enabled / 1 = disabled
1 = enabled / 0 = disabled
This parameter defines the polarity of the
disable object.
• The disable function will always be
deactivated (object value “0”) after a bus
or mains voltage return or after
programming the application with the
ETS. In the inverted setting ("1 =
enabled; 0 = disabled"), a "0" telegram
update must first be transmitted after the
initialization before the disabled status
will be activated.
• This parameter becomes visible only if
the disable function is enabled.
To Next Page
Loading...