hager
"DALI Gateway C00Cx2" software
Parameters
Seite 117 von 130
Response at the end of
the disable function
(continued)
Memory value (brightness
prior to the last shutoff)
Tracked brightness value
At the end of the disable, the value will be
adjusted to the brightness value that was
active and internally stored prior to the last
switch-off (via the “Switching” or “Switching
central function” object). This memory
value is non-permanently stored so that the
value is pre-defined to the maximum
brightness after the return of bus voltage or
after programming with the ETS. The bus
mode of the group will be re-enabled
afterwards.
Time functions will be included.
At the end of a disable, the status received
or set prior to the executed disable function
will be resumed with the applicable
brightness value. If applicable, active time
functions will also be considered.
• This parameter becomes visible only if
the disable function is enabled.
To Next Page
Loading...