hager TX216 - Page 122

hager
"DALI Gateway C00Cx2" software
Parameters
Seite 122 von 130
Dimming
Time for relative dimming
(0...100%)
00:00:01 … 05:59:59
[hh:mm:ss]
5 s
This parameter will set the relative time
increments (4-bit dimming). The time
entered defines the maximum duration for
the dimming across the entire brightness
range from 0 % to 100 % brightness.
Dimming response to a
brightness value
Dim
Jump to
This parameter determines whether a
brightness value received via the bus
(absolute dimming) will be instantly jumped
to or whether light intensity will dim to the
brightness.
Time for absolute
dimming (0...100%)
00:00:01 … 23:59:59
[hh:mm:ss]
5 s
This parameter will set the time for the
increments increments (1-byte dimming).
The time entered defines the maximum
duration for the dimming across the entire
brightness range from 0 % to 100 %
brightness.
• This parameter becomes visible only
when set to: “Dimming response to a
brightness value” = “Dim”.
Automatic shutoff when
falling below a specified
brightness ?
Yes
No
The automatic shutoff function for a group
can be activated. If activated, the DALI
devices of the group will shut off completely
as soon as a parameterized brightness has
been reached or under-run at the end of a
dimming operation and, if applicable, after
the delay time has lapsed.
Shutoff when brightness
value smaller
0.1 % … 100 %;
5 %
This parameter determines the brightness
to be reached or under-run at the end of a
dimming operation that will cause the group
to be switched off, if applicable, after the
delay time has lapsed.
• The adjustable value is restricted by the
parameterized minimum and maximum
brightness. The standard setting will also
adapt accordingly.
• If the shutoff brightness has been under-
run by a disable or forced-control
position function or a staircase pre-
warning function, the shutoff function will
not be executed.
• This parameter becomes visible only if
the shutoff function has been enabled.