hager
Fitting, electrical connection and operation
Seite 16 von 130
Controlling a DALI group manually
The DALI Gateway has been programmed at least once via the ETS.
Manual control mode (permanent or temporary) has been activated.
Select desired group: Press the key briefly (repeatedly, if necessary).
The 7-segment display will display the group number of the activated DALI group. The "ON/
"
(1...100 %) or "OFF/
" (0 %) status LED on the keypad indicates the brightness of the group.
Control the group by pressing the ON/ or OFF/ key.
Brief press: Switching on/off.
Long press: Increasing/decreasing brightness.
Long press & releasing: Stop dimming.
The activated DALI group will immediately execute the corresponding commands.
Switching off all groups
Permanent manual control mode has been activated:
Press the ALL OFF key.
All groups are shut off immediately (brightness: 0 %). The groups are not locked. Subsequently, they
can again be individually controlled.
• The "ALL-OFF" function is not available in temporary manual control mode.
Disabling bus mode of individual groups manually
The DALI Gateway has been programmed at least once via the ETS.
Permanent manual control mode has been activated:
The disabling of the bus mode must have been enabled in the ETS.
Select group: Press the key briefly (repeatedly, if necessary)
The 7-segment display will display the group number of the activated DALI group. The "ON/
"
(1...100 %) or "OFF/
" (0 %) status LED on the keypad indicates the brightness of the group.
Press the ON/ and OFF/ keys simultaneously for at least 5 s.
The relevant DALI group is now disabled (no bus mode possible).
The 7-segment display for the relevant group is blinking.
• To unlock, proceed in the same way.
• A group that has been disabled manually can only be operated in the permanent manual control
mode.
To Next Page
Loading...