hager
Fitting, electrical connection and operation
Seite 9 von 130
Installing / removing the protective cap
To protect the bus lines against hazardous voltages, especially in the area of the connecting terminals,
a protective cap can be installed.
The cap is installed with the bus terminal in place and the connected bus line led out at the rear.
To install the cap: Slide the cap over the bus connecting terminal until it is heard to engage (cf. Fig.
3.A).
To remove the cap: Remove the cap by pressing the sides slightly and by pulling it out to the front
(cf. Fig. 3.B).
AB
Fig. 3: Installing / removing the protective cap
To Next Page
Loading...