To Next Page
D
Denise MurphySep 15, 2025
Why Hagie STS12i Combo only one unit lifts slowly?
- SsusandiazSep 16, 2025
If only one unit lifts slowly, replace the valve and lubricate/loosen the pivot point.
Why Hagie STS12i Combo only one unit lifts slowly?
If only one unit lifts slowly, replace the valve and lubricate/loosen the pivot point.
What to do if Hagie STS12i Combo engine overheats?
If your Hagie Paint Sprayer engine overheats, you can try the following: reduce the load, remove any foreign material and clean all components, replace the cap, check the fan speed, replace the thermostat, and refill the coolant to the recommended level.
What to do if Hagie STS12i Combo Paint Sprayer engine will not start?
If the engine won't start, try these steps: fill the fuel tank, replace the fuel filters, check the starter and battery, and inspect the fuse. For cold weather starting, please refer to the engine manufacturer’s operation manual.
Why Hagie Paint Sprayer entire electrical system is dead?
If the entire electrical system is dead, try these solutions: replace the battery, clean and tighten battery connections, tighten the alternator belt, replace the alternator, and ensure the Battery Disconnect Switch is turned ON.
Why Hagie Paint Sprayer only one unit will not hold position?
If only one unit will not hold position, repair the leak or replace the hose, replace the valve, and remove, clean, and replace the components.
Why in AUTO mode, wrong unit raises from photo sensor of Hagie STS12i Combo Paint Sprayer?
If, in AUTO mode, the wrong unit raises from the photo sensor, attach the correct hoses to the proper cylinder.
Why Hagie STS12i Combo AWS System does not work, machine will only move at slow speed?
If the AWS System doesn't work and the machine only moves at slow speed, move the Hydrostatic Drive Control Handle to NEUTRAL, wait for the “FAULT” drive state to disappear on the Machine Display, and restart the machine. Note: In Road mode, the rear tires are locked until the machine is put into Field mode.
Why Hagie STS12i Combo lifting mechanism will not lift?
If the lifting mechanism won't lift, check the cylinder (remove, rebuild, or replace), remove and inspect components (replace with new if needed), loosen mounting bolts, and lubricate grease fittings (if equipped).
Why Hagie STS12i Combo noisy hydrostatic system?
If the hydrostatic system is noisy, allow an adequate warm-up period, increase the engine speed, and fill the reservoir to the proper level with approved oil.
Why Hagie STS12i Combo machine will not move in either direction?
If the machine will not move in either direction, ensure the engine is set at operating RPM before attempting to move the machine, fill the reservoir to the correct level with approved oil, and replace the charge filter.
General| Brand | Hagie |
|---|---|
| Model | STS12i Combo |
| Category | Paint Sprayer |
| Language | English |
