Hague Quality Water Maximizer 410 User Manual (English)

Questions and Answers:

D
Daniel ChaseJul 31, 2025
Why is there no soft water after regeneration in my Hague Quality Water Maximizer 410 Water Dispenser?
- J
  Jordan JohnsonJul 31, 2025
  If you're not getting soft water from your Hague Quality Water Water Dispenser after regeneration, it could be due to several reasons. First, check if there's enough salt in the brine cabinet and add more if needed. Sediment buildup might be blocking the brine line or air check/draw tube; if so, remove and flush these components, clean the injector assembly, and clear any sediment from the brine cabinet. A plugged flow control can also cause this issue; remove the brine piston housing to clear any debris. Ensure the drain line isn't pinched, frozen, or restricted. A clogged injector assembly requires removing the injector cap and cleaning the nozzle and throat. Finally, a salt bridge may have formed; break it up with a blunt object or use hot water to loosen it.
A
Allen GravesAug 4, 2025
What to do if my Hague Quality Water Maximizer 410 has no soft water?
- J
  Janet RiosAug 4, 2025
  If your Hague Quality Water Water Dispenser isn't producing soft water, there are a few things to check. First, make sure the bypass valve is in the Service position. Also, verify that the appliance is plumbed correctly. If there has been an extended power outage, reset the time of day. If the water hardness has increased, re-test the water and enter a new setting number. Finally, confirm that the appliance is metering water by checking if the WaterMizerTM light flashes with water usage.
D
Dennis RoweAug 8, 2025
How to dissolve salt bridge in Hague Quality Water Maximizer 410 Water Dispenser?
- B
  Bridget HubbardAug 8, 2025
  If a salt bridge has formed in your Hague Quality Water Water Dispenser, it's likely due to high humidity or using the wrong type of salt. To resolve this, test the salt with a blunt object like a broom handle to dislodge the bridge. Alternatively, you can pour hot water around the inside perimeter of the brine tank to loosen the salt.
T
Terry AyersAug 12, 2025
How to clean clogged injector assembly in Hague Quality Water Maximizer 410?
- S
  Susan RodriguezAug 13, 2025
  To resolve a clogged injector assembly in your Hague Quality Water Water Dispenser, start by removing the injector cap. Then, carefully clean the nozzle and throat using a wooden toothpick. If the throat was removed during cleaning, make sure to replace it afterward.
M
Melanie ArmstrongAug 17, 2025
What to do if drain line is blocked in Hague Quality Water Maximizer 410?
- E
  Erin WyattAug 17, 2025
  To fix a pinched, frozen, or restricted drain line in your Hague Quality Water Water Dispenser, straighten any kinks, thaw any frozen sections, or clear any blockages in the line.