Use and Care
Customization options are available to address any specic concerns you may
have. The best way to establish your specic needs is to conduct a water test.
Contact us by phone: (888) 245-3114 or online: www.hahnltration.com,
to make arrangements and get recommendations.
Component One: Sediment Pre-lter (included with standalone systems)
Sediment levels vary from one location to another. During the rst year of use, a
visual inspection monthly is recommended. The sediment pre-lter is white when
you initially install it. Once you can no longer see white, it is time to replace the
lter with a new one (HF-PRE10). Allowing sediment to continue to collect can
cause clogging and prevent the ow of water into your home.
Component Two: Whole House Filter
This lter unit has a capacity of 600,000 gallons. You replace the unit in
its entirety every 600,000 gallons. Check with your plumber at the time of
installation about adding a meter to your system. Typically the average family of
four will consume that amount in 6 years. Unions are located on each side of
the tank for ease of replacement. It is not necessary to contract a plumber. The
replacement part number is HF-600-R — available at hahnltration.com.
Specications
Model: HF-600
Replacement Cartridges:
Main Tanks: HF-600-R
Pre-Filter: HF-PRE10
Rated Service Flow: 7 gpm / 26.49 lpm
Max Working Pressure: 20-100 psi / 137-689 kPa
Max Operating Temperature: 40-90° F / 4.44-32.22˚ C
Max Capacity: 600,000 gal / 2,271,247.07 L
Do not use with water that is microbiologically unsafe or of unknown
water quality without adequate disinfection before or after the system.
To Next Page
Loading...