EN
5- Use
5.1 Before rst use
▶ Remove all packaging materials, keep them out of children`s reach and dispose
them in an environmentally friendly manner.
▶ Clean the inside and outside of the appliance as well as the interior and accessories
with water and a mild detergent and dry it well with soft cloth.
▶ After the appliance has been levelled and cleaned, wait for at least 2 hours before
connecting it to the power supply. See Section INSTALLATION.
▶ Precool the compartments at high settings before loading with food. The functions
Super-Freeze and Super-Cool help to cool down the compartments quickly.
▶ The refrigerator temperature and freezer temperature are automatically set to 5° C
and -18° C respectively. These are the recommended settings. If desired, you can
change these temperatures manually. Please see ADJUST THE TEMPERATURE.
Notice: Presettings
▶ The appliance is preset to the recommended temperature of 5°C (refrigerator) and
- 18°C (freezer). Under normal ambient condition you need not to set a temperature.
▶ The presetting function for the My Zone compartment is Chiller.
▶ When the appliance is switched on after disconnection from the main power supply, it
may take up to 12 hours for the correct temperatures to be reached.
Empty the appliance before switching o. To switch o the appliance,pull the power cord
out o the power socket.
11
5.3 Switch on /o the appliance
The appliance is in operation as soon as it is connected to the power supply.
When the appliance is powered on for the rst time, temperature indicators “a” and
“c”show the presetting values (refer to NOTICE ).
5.4 Standby-mode
The display screen turns o automatically 30 seconds after pressing a key. The display will
be automatically locked. It lights up automatically by touching any key or opening the door .
5.2 Sensor keys
The buttons on the control panel are sensor keys, which already respond when lightly
touched with the nger.
Notice: Panel lock
The control panel is automatically blocked against
activation if 30 seconds no key is touched. For any
settings the control panel must be unlocked.
▶ Touch key “G” for 3 seconds to block all panel ele-
ments against activation (Fig. 5.5-1).
▶ The related indicator “g” is now displayed (Fig. 5.5-2).
▶ For unlocking touch again the key.
5.5 Lock/unlock panel
Lock
Hold 3 Sec.
5.5-1 5.5-2
To Next Page
Loading...
