10- Installation
EN
32
After the change of the door check that the door seals
are located properly on the housing and all screws are
tightened well.
12. Take out the new lower hinge of upper door from
the accessory bag and screw it to the left side of
the appliance.
13. Lift the upper door carefully on to the lower hinge
so that the pivot ts into the hinge barrel.
12.
13.
14. Take out the upper hinge from the accessory
bag. Put the connection cable through the up-
per hinge and x the upper hinge with the three
screws on left side of appliance.
15 Put the hinge cover (delivered in the accessory
bag) over the hinge.
16. Plug in the connection cable and t it into the
opening.
17. Replace front panel and x it with the ve screws.
18 Take out the cover from the accessory bag and x
it to the right side of upper door.
14.
17.
16.
18.
Be sure the pivot ts into the hinge barrel of up-
per door.
To Next Page
Loading...
