This appliance is filled with R32
Read the precautions in this manual
carefully before operating the unit.
Read the operator's manual
Service indicator; Read technical
manual
Keep this manual where the user can easily fìnd
AWARNING
Do not use means to accelerate the defrosting process or to clean, other than those recommended by the
manufacturer.
The appliance must be stored in a room without continuously operating ignition sources (for example: open
flames, an operating gas appliance or an operating electric heater).
Do not pierce or burn.
Be aware that refrigerants may not contain an odour.
If the supply cord is damaged, it must be replaced by the manufacturenits service agent or similarly
qualified persons in order to avoid a hazard.
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given superivision or instruction
concering use of the appliance in a safe way and understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be made by children without supervision.
The wiring method should be in lino with the local wiring standard.
Alt the cables shall have got the European authentication certificate. During installation, when the
connecting cables break off, it must be assured that the grouding wire is the last one to be broken off. The
explosion-proof breaker of the air conditioner should be all-pole switch. Distance between its two contacts
should not be no lesa than 3mm. Such means for disconnection must be incorporated in the wiring.
Make sure installation is done according to local wiring regulation by professional persons.
Make sure ground connection is correct and reliable.
A leakage explosion-proof breaker must be installed.
Do not use a refrigerant other than the one indicated on the outdoor unit(R32) when installing, moving or
repairing. Using other refrigerants may cause trouble or damage to the unit, and personal injury.
The installation and service of this product shall be carried out by professional personnel, who have been
trainedand certified by national training organizations that areaccredited to teach the relevant national
competency standards that may be set in legislation.
Mechanical connectors used indoors shall comply with ISO 14903. When mechanicalconnectors are
reused indoors, sealing parts shall be renewed. When fiared joints arereused indoors, the fiare part shall
be re-fablicated.
This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or
for commerciai use by lay persons.
Disconnect the appliance from its power source during service and when replacing parts
1
To Next Page
Loading...
