Electic Control and
Debugging
429
Super Match
1. Use the "leftward" key and "rightward" key to check the fault codes inside the unit; where <1> can be 1 to 16,
which is the address code within the wired controller group.
2. In the current interface, keep both the "left" key and "right" key pressed down for 5 seconds to clear the historic
faults record.
3. A common user can view the current faults and historic faults; a high-class user can view 10 historic faults, using
the "downward" key and "upward" key. If a common user presses the "downward" key, a window as shown in
Figure 15; a high-class user can enter his/her password to view ten historic faults.
Figure 15
Fault code query:
Proceed through main interface→Menu→Other→enter password→press "Enter" key→Error code→enter 14.
The password entry interface is shown in Figure 13 and the entry method is the same as password setting.
Figure 13 Figure 14
To Next Page
Loading...
