To Next PageTo Next Page
Need help?Do you have a question about the Haier AD09SS1ERA(N)(P) and is the answer not in the manual?
General| Power Supply | 220-240V, 50Hz |
|---|---|
| Operating Temperature (Cooling) | 18-43 °C |
| Cooling Capacity | 9000 BTU/h |
| Cooling Capacity (kW) | 2.6 kW |
| Power Input Cooling (W) | 810 W |
| Outdoor Unit Dimensions (WxHxD) | 700x245x544 mm |
Guidance on safely disposing of old air conditioners and their components.
Information on environmentally friendly disposal of new air conditioner packaging materials.
Crucial instructions and warnings for safe operation and installation of the air conditioner.
Essential precautions to follow during the installation process of the air conditioner.
Guidelines and warnings related to moving or repairing the air conditioner unit.
Checks to perform when the air conditioner unit does not power on or start.
Troubleshooting steps for insufficient cooling or heating performance.
Specific checks for inadequate cooling performance, including environmental factors.
Explanation of normal operational sounds and phenomena that are not considered malfunctions.
Critical safety warnings and requirements for proper and safe air conditioner installation.
Important cautions and recommendations for electrical work and drain pipe installation.
Details on installing the air conditioner unit relative to the building's ceiling and roof structure.
Diagram illustrating the layout and connection of long air ducts.
Steps for installing the air sending duct, including diameter and connection requirements.
Procedure for connecting the air return duct to the indoor unit.
Instructions for applying thermal insulation to air supply and return ducts.
Methods for installing suspension screws for mounting the air conditioner unit.
Process for hanging the indoor unit onto the installed suspension screws.
Details on refrigerant pipe sizes, material, and connection torque specifications.
Parameters for permissible pipe length and vertical drop for refrigerant lines.
Guidelines for adding supplementary refrigerant, including measurement requirements.
Instructions for connecting refrigerant pipes, including torque and wall thickness specifications.
Procedure for creating a vacuum in the refrigerant lines before charging.
Methods for checking for gas leaks at pipe connections and bonnets.
Guidelines for insulating refrigerant pipes to prevent dew generation.
Requirements and procedures for installing and insulating the drain pipe.
Instructions for installing and insulating the drain hose and its connection.
Checking for leaks during the trial run, especially during water drainage.
Specific warnings and recommendations for performing electrical wiring work safely.
Diagram and instructions for connecting the power supply wiring to the indoor and outdoor units.
