Haier ADH071M3ERG - Page 222

220
Smart Power
(2) Auto mode will not start HEAT function automatically, but can set or cancel HEAT function.
20. Timer:
(1) TIMER ON
• Press "TIMER ON" button, character "ON" is ashing, press "+/-" button to adjust, then press "OK" button to
conrm, if "OK" button is not pressed within 10 s, TIMER ON function is cancelled.
• If time of TIMER ON is the same as that of clock at present, character "ON" is always ashing and can not be
veried, it is necessary to readjust time.
• When the time of TIMER ON is end, the setting time and character "on" disappear.
(2) TIMER OFF
• Press "TIMER OFF" button, character "OFF" is ashing, press "+/-" button to adjust, then press "OK" to conrm, if
"OK" is not pressed within 10 s, TIMER OFF function is cancelled.
• If time of TIMER ON is the same as that of clock at present, character "OFF" is always ashing and can not
veried, it is necessary to readjust time.
• When the time of TIMER OFF is end, the setting time and character "OFF" disappear.
(3) TIMER ON/OFF
• After TIMER ON/OFF is set, remote will automatically judge sequential order of ON/OFF, arrow indicates that the
one performed rst points to the one performed second.
• After the time of clock performed rst is end, corresponding characters of timer "ON/OFF" disappear.
• If time of TIMER ON is the same as that of TIMER OFF, and can not be veried, corresponding character of the
latter of setting time is always ashing, it is necessary to readjust time and conrm again.
• If time of TIMER ON/OFF is the same as that of clock at present, and can not be veried, it is necessary to
readjust time and conrm again.
(4) After setting timer, display the setting of timer rst and then display time all the time, when timer is active,
character "ON/OFF" is always displayed.
21. Button +/-:
• Press button "+/-" time will change in terms of 1 min as unit, pressing and holding the button will change quickly.
22. Clock:
• Press "Clock" button, "Morning" or "Afternoon" displayed at present are ashing to enter the state of clock
adjustment, adjust clock and then press "OK" to conrm.
• It is valid under the state of ON/OFF.
23. LIGHT:
• No display on remote controller LCD, which is processed by indoor unit.
24. RESET:
• Perform one power on reset operation when RESET button is pressed.
25. LOCK:
• Press button Lock, display Lock symbol on LCD display, buttons on remote controller can not be used, press
button Lock again to unlock.
26. CODE:
• Function reserved.
27. INQUIRE
• Processing by Indoor unit