Haier ADH071M3ERG - Page 223

221
Smart Power
Key
ON/OFF
Adjusting key for temperature, clock, timer, sleeping adjustment, temp. compensation and energy saving;
Inquiring key for detail parameter and malfunction inquiry;
Switching key for function switch.
The adjusting accuracy of temperature is 0.5°C. If energy saving mode is not set, the adjusting range is from 16°C
to 30°C. If energy saving mode is set, the lowest temperature limit of cooling/dry and the highest temperature
limit of heating are decided by the setting of the chip, the default cooling/dry temperature is 23°C, and the default
heating temperature is 26°C.
Note:
• If the dip switch Sw2 is “on”, it displays the ambient temp., as well as when powered off. From power off to power
on, mode switching and set temp. adjustment, it ashes to display SET icon and statically displays the set temp..
And then statically displays the ambient temp. and ROOM icon after 3 seconds. In energy saving mode and temp.
compensation mode, the adjusting step is 1°C a time.
• If using Fresh Air unit, set temp. cannot be adjusted. If there is no Central/Lock set, the temp. will be xed at 18°C
in cooling and 22°C in heating. The Up/Down key will not display in normal state, but will display and valid in timer
setting, function selection, unit shift in malfunction inquiry, parameter shift in parameter check, unit No. setting,
sleeping time adjustment, etc.
• If Sw2 is set to be on, meaning ambient temp. display, ambient temp. will be displayed in off state; when in the
state of OFF→ON, mode shift, set temp. adjustment, the set temp. will display statically, SET icon ashes and after
3s, ambient temp. and ROOM icon display statically .
24-hour, press once to minus one minute. Keep pressing, minus 2 minutes in 1 second’s pressing, then 10
minutes in 5 seconds. The time will keep decreasing at the pace of 10 minutes a time in 10 seconds. Vice-versa.
Press to conrm or it will turn back to the previous state automatically in 10s.
7.2 Wired controller: YR-E17