Operation
°
°
气
°
屯
°
1.After unit starts, select your desired operation mode.
2.Press // button to change TIMER
ON
OFF
3.
PresPresss
button " TIMER OFF " will appear ,after
10 seconds the time display will be blank.
Then select your desired TIMER mode (TIME ON or
TIME OFF ). " "or " "will flash.
Press / button to set time.
Each press will increase or decrease 1min. If the
button is kept pressed, time will change quickly.
button and confirm
After adjust the time,press
the time ON or OFF button will not flash any more.
4.Confirm timer setting
5.Cancel timer setting
Press the button the time display eliminated.
Hints:
After replacing batteries or a power failure happens,
time setting should be reset.
According to the Time setting sequence of TIME ON or
TIME OFF, either Start-Stop or Stop-Start can be
achieved.
TIME
TIME
PresPresss button " TIMER ON " will appear ,after
10 seconds the time display will be blank.
TIME
ON
OFF
TIME
•
TURBO/QUIET
Operation
1.TURBO Operation
When you need rapid heating or cooling, you can
choose the TURBO function. Press TURBO button, the
remote controller will show , and then achieve to the
TURBO function. Press again this TURBO button , the
TURBO function will be cancelled.
2.QUIET Operation
You can use this function when silence is needed for
rest or reading. Press QUIET button, the remote
controller will show , and then achieve to the quiet
function. Press again this QUIET button , the quiet
function will be cancelled.
Note:
During POWER operation, in rapid COOL mode ,
the room will show inhomogeneous temperature
distribution.
Long period QUIET operation will cause effect of not
too cool or not too warm.
To Next Page
Loading...
