SWING Operation
To cancel TIMER mode
Just press TIMER button several times until TIMER
dispiay disappear.
Operation
TIMER
Set Clock correctly before starting Timer operation. You can
let unit start or stop automatically a following times: Before
you wake up in the morning, or get back from outside or
after you fall asleep at night.
mode.
Time setting.
Remote controller: “
TIMER ON
”
Remote controller: “
TIMER OFF
”
“
ON
” or “
OFF
”
Every time the button is pressed,
time setting increases or decreases
Select your desired
TIMER ON.
Select your desired
TIMER OFF.
TIMER Operation
1
1
2
1 min, if kept depressed, it will increase rapidly. It can be
adjusted within 24 hours.
APPLY
Select your desired operation
3
COOL/DRY:
For each press of “
” button, air
displays as follows according to
different operation modes:
When humidity is high, condensate water might occur
at air outlet if all vertical louvers are adjusted to left or
right.
position for a long time in COOL or DRY mode,
otherwise, condensate water might occur.
1
2
HEAT:
SMART:
Initial state
Initial state
For each press of “
” button, remote controller
displays as follows:
remote controller:
6
To Next Page
Loading...
Need help?
General
