Operation
Clock set
Note:
Note:
The distance between the signal transmission head and
the receiver hole should be within 7m without any obstacle
change-over wireless telephone is installed in the type
in receiving the signals, so the distance to the indoor unit
should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller can’t run normally during operation,
please remove the batteries and reload several minutes later
Hint:
Remove the batteries in case unit won’t be in usage for
a long period.
20. 10 ºC button
special heating set
function: 10 degree
heating maintaining
(valuable for RS)
18. buttonTIMER
23. SWING up/down button
24. SWING left/right button
19. buttonCLOCK
26. HEALTH AIRFLOW button
21. HEALTH button
28. CODE button
A-b yard
29. APPLY button
30. °F/°C button
25. SLEEP button
19
20
21
22
23 24
25
26
27
28
29
30
18
22. SMART button
Used to set SMART
operation. (This function
is unavailable on some
models.)
27. LIGHT button
Control the lightening and
extinguishing of the indoor
LED display board.
Press CLOCK button,
Press “+” or “-” to set
correct time.
Each press will increase or
decrease 1min. If the button is
kept pressed, time will change
quickly.
press APPLY, “AM” and
starts working.
1
2
3
2
1. SMART+SLEEP:When the light sensing function is enabled,
the appliance will be in the
mode. If the appliance
detects that indoor light is weak (lower than the setting
value) for several minutes, the light sensing function
works automatically. If theappliance detects no movements
of people for 20 minutes , during which the light is weaker
than the setting value , it will enter the “SMART+SLEEP”
mode automatically. The appliance will operate as per the
sleep curve.(See the“SLEEP”function in Page 7).
Conditions to exit:
1) The appliance detects that the indoor light is stronger
than the setting value for 20 minutes.
2) The appliance is in the 8h “SMART + SLEEP” mode.
3) The “LIGHT SENSING” function is disabled.
When any of the above conditions is met, the appliance will
exit from the “SMART+SLEEP” mode. Once out of the
“SMART+SLEEP” mode, the appliance will operate under
the operation status initially set on the
remote controller.
Note:1) This function is not available in the “AIR SUPPLY”
mode.
2) This function is not available in the “SLEEP”mode.
3) When it is in the "REMOTE SLEEP” mode or the
“TIMER”is on, the appliance will exit from this function.
4) Light sources like indoor lamps and TV’s LED
light,and frequent movement s of pets will affect this
function.
2.
Press “HEALTH”+“HEALTH AIRFLOW” simultaneously can
set and cancel the “LOCK” function ( )
To Next Page
Loading...
Need help?
General
