ON/OFF Operation:
Use this operation only when the remote controller is
defective or lost, and with function of emergency running,
air conditoner can run automatically for a while.
When the emergency operation switch is pressed, the
“Pi” sound is heard once, which means the start of this
operation.
emergency operation starts, the unit will run automatically in
the following modes:
Room
temperature
Designated
temperature
Timer
mode
Fan
speed
Operation
mode
Above 24 ºC 24 ºC No AUTO COOL
Below 24 ºC 24 ºC No AUTO HEAT
It is impossible to change the settings of temp. and fan
speed, It is also not possible to operate in timer or dry mode.
Test operation:
T
est operation switch is the same as emergency switch.
Use this switch in the test operation
when the room temperature is below
16 ºC, do not use it in the normal
operation.
Continue to press the test operation
switch for more than 5 seconds.
After you hear the “Pi” sound twice,
ON/OFF operation and test operation
Operation
Pi
Pi Pi
9
HEALTH Operation
Press HEALTH
button
Press HEALTH button for twice press,
disappears, the operation stops.
For each press, is displayed
Air conditioner starts health
function operation.
Pi
the cooling operation starts with the
air flow speed “Hi”.
Pi Pi
UV sterilization function: it uses the c-band with the
most effective sterilization effect in ultraviolet radiation
to remove harmful microorganisms such as bacteria
in the air, with remarkable effect and make the air
healthy.
Attention：
1.It is recommended to turn on the UV sterilization
function for 1-2 hours in one day, longer time will
affect the life of the UV lamp.
2.Do not look directly at the UV lamp or touch it with
your hand when the sterilizing function is on. Please
turn off the sterilizing function before opening the
panel.
3.Tinged blue light may appear near the air
conditioning inlet when the sterilizing function is on.
4.Only when the internal fan starts and health function
turned on, the UV lamp will be lighted.
To Next Page
Loading...
Need help?
General
