Haier AS25TADHRA-TC - Parts and Functions; Indoor Unit Components; Remote Controller Overview; Outdoor Unit Components

Parts and Functions
Indoor Unit
Remote controller
1
6
8.
Additional functions display
2
Supplemented
Operation mode
QUIET
SLEEP
electrical
HEALTH
TURBO
heating
1
Inlet
4
Air Purifying Filter
7
(inside)
Remote controller
3
4
2
Inlet grille
33
Outlet
5
Anion generator
(inside)
5
8
8
9
Emergency
18
Switch
10
11
19
6
Vertical blade
20
(adjust left and
7
12
Horizontal flap
r
ight air fl
ow)
Display board
21
(adjust up and down air flow
13
Don't adjust it manually)
22
14
23
15
SELF
CLEAN
24
16
17
25
1. Mode display
Function: Sleeping---- Health---- Healthy
airflow position1--- Healthy airflow
position 2 --- Power --- Air sending
--- A-B yard
Operation mode
AUTO COOL DRY
FAN
HEAT
Remote controller
Display
circulated
LO MED HI
AUTO
TIMER ON display
7. TEMP display
the remote.
Healthy function is not available for some units.
Loading of the battery
Outdoor Unit
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
is in line with th
e" + "/"-";
4
Load the battery,then put on the cover again.
Note:
4
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
type fluorescent lamp or
wireless telephone is installed in the
room, the recei
ver is apt to be disturbed in receiving
the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte
ries have been used up.
Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and
reload several minutes later.
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
INLET
DRAIN HOSE
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
Please be subject to the actual produce purchased the
above picture is just from your reference
9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
13. FAN SPEED button
14. TIMER button
15. SELF CLEAN button
16. LOCK button
Used to lock buttons and LCD display
17. LIGHT button
Control the lightening and extinguishing
of the indoor LED display board.
18. POWER ON/OFF button
19. DRY button
20. TEMP button
21. SWING button
22. HOUR button
23. EXTRA FUNCTION button
2. Signal sending display
3. SWING display
4. FAN SPEED display
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
25. RESET button
When the remote controller appears
abnormal, use a sharp pointed
article to press this button to reset
5. LOCK display
6. TIMER OFF display
Display board
1
Signal receiver
2
Setting temp.display
1
2
Actual inlet grille may vary from the one shown in the
manual according to the product purchased